Epson Refill Instructions

C41,42,43,44,45,46,48,60,61,62,CX3100,3200,Stylus 680,685,777

TO17,TO18,TO26,TO27,TO28,TO29,TO36,TO37

TO38,TO39,TO40,TO41,TO66,TO67

All the above are chipped and therefore need resetting.

Empty cartridges left for more than 3 days do not always give a successful re-fill.

Please check before filling that your colours correspond with the instructions.

Assemble the needle and syringe, place the needle into the ink inlet hole and push until slight resistance is felt.

Remove the needle from the cartridge, this will allow you to see a small amount of colour on the needle.

If the colours are different from those on the instructions supplied, then fill the chambers as per the appropriate colour sequence in your cartridge

The filling holes are located on the top of the cartridge under the label (see above).

Using the eye screw provided make a hole in the cartridge(see above).

Some cartridges have a ball bearing instead, in this case push the ball bearing into the cartridge.

Fill the syringe with the appropriate colour ink.

Push the needle into the filling hole, almost to the bottom of the cartridge.

Slowly inject the ink, whilst withdrawing the needle.

When ink starts to appear at the filling hole, stop.

Then draw a small amount of the ink out of the cartridge.

Do not reseal the filling holes.

Return the cartridges to the printer and run 1 -3 cleaning cycles as per your printer instructions.