Canon PG-40 PG-50 CL-41 CL-51 Refill Instructions

ip1200/ip1300/ip1600/ip1700/ip1800/ip2200
ip2400/ip2500/ip2600/ip6210D/ip6220D
mp140/mp150/mp160/mp170/mp180/mp210/mp220
mp450/mp460/mx300/mx310

Put the cartridge on some paper towels in an area where you can tolerate a spill.

Drill a holes as shown in the pictures. Three small holes in the colour & one in the black.

Fill the syringe with the correct colour ink.

Please check before filling that your colours correspond with the instructions.

Assemble the needle and syringe, place the needle into the ink inlet hole and push until slight resistance is felt. Remove the needle from the cartridge, this will allow you to see a small amount of colour on the needle.

If the colours are different from those on the instructions supplied, then fill the chambers as per the appropriate colour sequence in your cartridge.

Very S-L-O-W-L-Y inject ink into any hole.

When finished, put a small piece of tape over the drilled hole.

Replace the cartridge and run 1 - 3 cleaning cycles as per printer instructions.

If necessary leave cartridge in printer for up to 24 hours.

If you have trouble getting your printer to print because it thinks the cartridges are empty. Look on your printer for an orange blinking light. This is your reset button. Hold this button in for 5 seconds until the light goes out.