1.Remove the print head from your printer.
2.Carefully place each silicon nozzle seals into position.
3.Incorrectly placed silicon seals can cause poor ink quality. Please ensure that the silicon seals do not move from position when inserting the cartridges.
4.Remove fill hole plug.
5.Fill syringe with ink then remove needle.
6.Insert syringe into hole left by removing " fill hole plug" you should push down firmly to ensure the syringe is tight and secure.
7.Slowly press down to fill ink cartridge.
8.When you let go the syringe will move up on its own, when it stops moving,pull back on the syringe to withdraw some air pressure.
9.Repeat steps 5,6,7,8 until cartridge is nearly 3/4 full and no more.
10.Remove the yellow pull tab.
11.Remove cartridge from orange cradle and insert into printer, sometimes there may be residue in orange cradle depending on how quickly you have pressed down on the syringe. Slower the better.Clean orange cradle and store for next time.
12.If you are not going to use the cartridges for more than 3 weeks we advise you re-cover the hole left by removal of the yellow tape - doing this will ensure the ink stays fresher - and does not dry out.
The chips are auto reset so after removal from the printer the ink level monitor will return to100% - if this fails simply switch the printer on and off.